Advertisement
8. SIMULATING THE HARDWARE STATUS
(3) Using the Simulation Tool window
When the RAS software transitions to the simulation mode, the Simulation Tool
window appears as shown in the following figure.
You can use the Simulation Tool window to change the condition of hardware devices.
When the Simulation Tool window starts, all hardware devices are set to the normal
status.
Shows the name of
a simulated device.
Figure 8-3 Description of Each Part in the Simulation Tool Window
Target
Shows the name of each simulated hardware device.
Fan condition
Temperature condition
inside the chassis
Drive condition
Shows the currently set
status of the target device.
Click Apply to apply
the "Setting".
Category
Case fan, CPU fan
Internal Temperature
Drive bay1, Drive bay2
Click End to exit the
simulation mode.
Target
8-6
Shows a new status
to be simulated.
Advertisement
