Advertisement
8. SIMULATING THE HARDWARE STATUS
End button
If you click this button, shutdown is executed to exit the simulation mode. Before
shutdown is executed, the following message is displayed. Save the data, for example,
and then click OK. If you click Cancel, the Simulation Tool window does not exit.
NOTE
Even if the Simulation Tool window exits due to an internal error or the like,
shutdown is executed automatically to exit the simulation mode. Before
shutdown is executed, the following message is displayed. Save the data, for
example, and then click OK.
Minimize button ([_] button)
Click the Minimize button at the upper right corner of the Simulation Tool window
to minimize the Simulation Tool window. Note that when the window is minimized,
the simulation mode does not exit.
Close button ([×] button)
Click the Close button at the upper right corner of the Simulation Tool window to
execute shutdown and exit the simulation mode. The behavior after this button is
clicked is the same as when you click End.
8-8
Advertisement
