Advertisement
4. CHECKING THE HARDWARE STATUS
(2) SNMP security configuration
1. In the "SNMP Service Properties" window, select the Security tab.
2. If you want to send a trap message whenever authentication fails, select the "Send
authentication trap" check box.
3. Under "Accepted community names," click Add. The "SNMP Service
Configuration" window is displayed. In the "Community rights" list, select READ
ONLY. In the Community Name box, type the community name you want, and click
Add.
4. Specify whether to accept SNMP packets from hosts.
If you want to accept SNMP packets from any manager on the network:
• Select Accept SNMP packets from any host.
If you want to restrict SNMP packets:
• Select Accept SNMP packets from these hosts.
• Click Add.
• The "SNMP Service Configuration" window is displayed. Enter the host name, IP
or IPX address of a host you want to accept the SNMP packets from, and click Add.
5. In the "SNMP Service Properties" window, click Apply.
4-24
Advertisement
