Advertisement
3. SETTING UP THE RAS FEATURE
In the Advanced window, you can set up a threshold for the drive power-on hours so
that you can be notified when the value of the drive power-on hours exceeds the
threshold. To set the notification threshold, from the Object list, select the drive you
want to set up. Type the value for the threshold in single-byte characters in the box in "It
reports when the used hours passes
hours." Then click OK.
Enter an integer value in hours ranging from 100 to 20000 in the step of 100 (100
(minimum), 200, ..., 20000 (maximum)). The default factory-shipped setting is 20000
(hours). If you want to clear the current cumulative power-on hours when click Reset to
clear the value. Then the following message is displayed.
If you click OK when you receive the message, the value of the current cumulative
power-on hours is cleared. Click Cancel to leave the value as is. If the drive usage
monitoring is disabled, this item cannot be set.
If you changed the settings in the Advanced window and want to make the change
effective, click OK.
If you do not want the change, click Cancel. The window is closed and the change is
discarded.
3-9
Advertisement
