GE AF-650 GP Programming Manual page 143

DR-12 Motor Rated Voltage
Range:
0.0 V* [0.0 - 6000.0 V]
DR-13 Frequency
Range:
0.0 Hz* [0.0 - 6500.0 Hz]
3
DR-14 Motor Current
Range:
0.00 A* [0.00 - 10000.00 A]
DR-15 Frequency [%]
Range:
0.00 %* [-100.00 - 100.00 %]
DR-16 Torque [Nm]
Range:
0.0 Nm* [-3000.0 - 3000.0 Nm]
DR-17 Speed [RPM]
Range:
0 RPM* [-30000 - 30000 RPM]
DR-18 Motor Thermal
Range:
0 %* [0 - 100 %]
DR-19 KTY sensor temperature
Range:
0 °C* [0 - 0 °C]
DR-20 Motor Angle
Range:
0* [0 - 65535]
DR-22 Torque [%]
Range:
0 %* [-200 - 200 %]
142
Function:
View the motor voltage, a calculated value used for controlling the motor.
Function:
View the motor frequency, without resonance dampening.
Function:
View the motor current measured as a mean value, IRMS. The value is filtered, and thus approximately
30 ms may pass from when an input value changes to when the data read-out values change.
Function:
View a two-byte word reporting the actual motor frequency (without resonance dampening) as a per-
centage (scale 0000-4000 Hex) of par. F-03 Max Output Frequency 1. Set par. PB-16 PCD Read Configu-
ration index 1 to send it with the Status Word instead of the MAV.
Function:
View the torque value with sign, applied to the motor shaft. Linearity is not exact between 160% motor
current and torque in relation to the rated torque. Some motors supply more than 160% torque. Conse-
quently, the min. value and the max. value will depend on the max. motor current as well as the motor
used. The value is filtered, and thus approx. 30 ms may pass from when an input changes value to when
the data read-out values change.
Function:
View the actual motor RPM. In open loop or closed loop process control the motor RPM is estimated. In
speed closed loop modes the motor RPM is measured.
Function:
View the calculated thermal load on the motor. The cut-out limit is 100%. The basis for calculation is the
Electronic Thermal Overload function selected in par. F-10 Electronic Overload .
Function:
Returning the actual temperature on KTY sensor buil into the motor.
See par. F-1#.
Function:
View the current encoder/resolver angle offset relative to the index position. The value range of 0-65535
corresponds to 0-2*pi (radians).
Function:
Value shown is the torque in percent of nominal torque, with sign, applied to the motor shaft.
AF-650 GP Programming Guide