Exporting Data - Huawei NetCol8000-E220 User Manual

NetCol8000-E220 Modular Indirect Evaporative
Cooling System
User Manual
●
●
●
To prevent key data from being lost, you are recommended to record all
parameter values or back up data with export configurations before restoring
defaults. Then change the parameter values back to the recorded values after
restoring defaults.

7.1.17 Exporting Data

Context
With the one-click mode, you can export active alarms, historical alarms, run logs,
and so on.
You are advised to use the FAT32 USB flash drive with a capacity no greater than
64 GB. Format the non-FAT32 USB flash drives into FAT32 ones before using them.
Before using a USB flash drive, ensure that its data has been scanned by antivirus
software and is secure.
Procedure
Step 1 Tap Maint > USB Operations > Export to enter the Select Path screen, as shown
in Figure
Issue 06 (2020-08-19)
All parameters except for language and time settings displayed on Settings >
Quick Settings.
Date format and time zone settings displayed on Settings > User Settings.
All parameters displayed on Maint > Sensor Calibration.
NO TICE
NO TE
After default settings are restored, all communication addresses are changed to 1 and the
communication between all devices and the EMS is disconnected. The communication
addresses must be reset to recover the communication.
NO TICE
NO TE
● Before exporting active alarms, historical alarms, logs, and configurations, ensure that
the USB flash drive has been successfully identified.
● If the USB flash drive has been successfully identified,
● If the USB flash drive is not properly connected, the system will display No USB device
found. during operations about the USB flash drive.
7-9.
Copyright © Huawei Technologies Co., Ltd.
7 FAQ
is displayed in the status bar.
233