3.
Cable insertion
Lift up the back of the plug cover, and insert the cable until it reaches the end. Insert each signal cable into the CC-Link
communication one-touch connector plug as shown in the following figure.
NOTE
• Insert the cable fully. Failure to do so may cause a crimping failure.
• A cable sometimes comes out of the head of the cover. In that case, pull the cable a little so that the cable stays under the
plug cover.
24
WIRING
5 4 3 2 1
Signal name
DA (Blue)
DB (White)
DG (Yellow)
Not used
SLD (Drain wire)