Table of Contents
Advertisement
Left Joystick
1. Raise the elevator
2. Lower the elevator
3. Open / Close the pipe gripper
4. Rotate the cam assembly
5. Go to the previous step in SmartTouch™ mode
1. Rotate the drill spindle counter clockwise (Drill Mode II)
2. No action
Push the joystick left and hold the cam rocker switch at the same time to use the cam override function.
Important:
This overrides the anti-crash prevention warning and could cause damage to the machine.
Push the cam rocker switch forward to rotate the cam assembly out.
Push the cam rocker switch backward to rotate the cam assembly in.
Figure 31
Left Joystick in
DRILL
6. Go to the next step in SmartTouch™ mode
7. Retract the pipe gripper arm
8. Extend the pipe gripper arm
9. Apply tread-joint compound
Figure 32
Left Joystick — Directional Controls
3. Rotate the drill spindle clockwise (Drill Mode II)
4. No action
31
mode
g226145
g226143
Advertisement
Table of Contents
