Specifications - Toro 2226 Operator's Manual

If you release the operator presence switch while
operating, you will need to release all of the controls
before resuming operation.
Operator Presence Switch
Push and hold this button to enable the other controls
on the travel pendant. The machine stops moving
when you release this button.
Engine Speed Switch
•
Push the top of this switch to increase the engine
speed in 100 rpm increments. Hold the switch to
rapidly increase to high idle.
•
Push the bottom of this switch to decrease the
engine speed in 100 rpm increments. Hold the
switch to rapidly decrease to low idle.
•
Release the switch to maintain the current engine
speed.
Tramming Direction Joystick
Use the joystick to control the direction of the machine.
The machine will travel in the direction you move the
joystick.
Error Indicator Light
This light lights up when the 2-speed button is pushed.
The light will blink there is an internal error with the
travel pendant.
Drive-Speed Switch
The switch sets the speed at which the machine
travels. Push the switch to alternate between high
and low speed.
Thrust Frame Switch
Use this switch to raise and lower the thrust frame.
Right Stabilizer Foot Switch
Use this switch to raise and lower the right stabilizer
foot.
Left Stabilizer Foot Switch
Use this switch to raise and lower the left stabilizer
foot.
Emergency Engine Stop Button
Push this button to immediately shut off the engine
and all movement/drilling operations. You must pull
this button out before you can start the engine again.
Battery-Disconnect Switch
Open the front hood to access the
B -D
ATTERY ISCONNECT
the Front and Rear Hoods (page
The -
BATTERY DISCONNECT
of the engine; it is used to electrically disconnect the
battery from the machine.
Important:
Do not use the battery-disconnect
switch to turn off the engine.
Turn the -
BATTERY DISCONNECT
position to perform the following:
•
To energize the machine electrically, rotate the
-
BATTERY DISCONNECT
position (Figure
•
To de-energize the machine electrically, rotate the
-
BATTERY DISCONNECT
the O position
FF

Specifications

Note:
Specifications and design are subject to
change without notice.
Machine
Width
Length
Height
Weight
34
switch; refer to Opening
67).
switch is located to the right
switch to the O
switch clockwise to the O
39).
switch counterclockwise to
(Figure 39).
Figure 39
147 cm (58 inches)
521 cm (205 inches)
198 cm (78 inches)
4,302 kg (9,485 lb)
or O
N FF
N
g218942