Table of Contents
Advertisement
Exit Side Lockout
The exit-side-lockout system provides the individuals
working around the machine with a means to disable
the drill pipe from rotating and thrusting.
For more information and instructions, refer to the
Operator's Manual for the Exit-side-lockout system.
Rear Control Panel
Figure 36
1. Travel pendant bracket
2. Fluid-pump switch
OK-to-Start Light
The green light illuminates when the machine is ready
to start.
If the light does not illuminate, check the 2 emergency
stop buttons. They need to be disengaged before the
machine can start.
Engine, Key Switch
The key switch has 3 positions as follows
Figure 37
1. Engine-off position
2. Engine-run position
g229102
3. Engine, key switch
4. OK-to-Start light
(Figure
36):
g220853
3. Engine-start position
•
Engine-off position—turn the key to this position to
shut off the engine. The engine cannot be started
from the operator platform when the key is in this
position.
•
Engine-run position—turn the key to this position
after starting the engine. Turning the key to this
position also enables the engine start button from
the operator platform.
•
Engine-start position—turn the key to this position
to start the engine. Release the key to the R
position once the engine has started.
Fluid-Pump Switch
Use this switch to turn on the fluid pump to use the
spray gun when cleaning the machine.
Travel Pendant
Refer to
Figure 36
for location.
1. Operator presence switch
(tramming)
2. Engine speed switch
3. Tramming-Direction
Joystick
4. Error indicator light (when
blinking)
5. Tramming speed switch
Use the corresponding operator presence switch to
operate the setup and tramming functions.
33
Figure 38
6. Thrust frame switch
7. Right stabilizer foot switch
8. Left stabilizer foot switch
9. Operator presence switch
(setup)
10. Emergency engine stop
button
UN
g225940
Advertisement
Table of Contents
