Table of Contents
Advertisement
emergency-engine-stop buttons are released
(Figure 29
and
Figure
6.
Turn the key to the S
engine starts, then release it.
To shut off the engine, turn the key to the O
In an emergency, you can also shut off the
engine and all processes by pushing the
E
-E
-S
MERGNECY
NGINE
TOP
pendant or the control panel.
Tramming the Machine
Refer to
Tramming Safety (page
1.
Raise the elevators.
2.
Install the lower pipe box pins.
3.
Lower the elevators.
4.
Switch the drill into
5.
Walk around the machine to ensure that no one
is near it. Ensure that all bystanders are clear of
the area where you will be moving the machine.
6.
Remove the travel pendant from the rear control
panel.
7.
With the travel pendant in hand, walk at least
6 feet to the side of the machine. Be sure to
keep this safe distance whenever moving the
machine.
8.
Push and hold the O
on the travel pendant.
9.
Use the speed switch on the pendant to increase
or decrease the engine speed as desired.
10.
Set the desired travel speed, using the speed
switch.
11.
Use the joystick to move the machine as desired.
Note:
For more information on the travel pendant,
refer to
Travel Pendant (page
38).
position until the
TART
position.
FF
button on either the travel
5).
mode
(Figure
29).
SETUP
-P
button
PERATOR
RESENCE
33).
Loading and Unloading the
Machine
WARNING
Moving a machine of this size on a trailer over
public roads carries risks to those around the
machine if it should come loose, be involved
in an accident, hit a low hanging structure,
etc.
• Follow the tie-down procedures described
in this section when moving the machine.
• Follow all local traffic regulations
governing the hauling of large equipment.
This manual cannot adequately cover all
laws and safety regulations; it is your
responsibility to know and follow the laws
and regulations that pertain to you.
WARNING
The machine can slip and fall from a trailer or
ramp, crushing anyone caught beneath it and
causing serious injury or death.
• Keep all bystanders away from the machine
and trailer.
• Ensure that the trailer and ramp are not
slippery and are free of ice, grease, oil, etc.
• Move the machine onto the ramp at slow
speed with the engine at slow speed.
• Ensure that you have the machine centered
on the ramp and trailer.
1.
Ensure that the ramp and the trailer or truck bed
can support the weight of the machine.
2.
Ensure that the upper pipe box straps and lower
pipe box pins are installed
1. Upper straps
2. Lower pins
48
(Figure
52).
Figure 52
g218951
Advertisement
Table of Contents
