34/61
Bosch Rexroth AG
Assembly
6.2.2
Assembly the Rotor
Stator fixing thread
Stator 1MS...
Dimensions
M8 / 22 mm
376
deep
M8 / 22 mm
480
deep
Fig.6-2:
Stator fixing thread
Refer to the respective stator dimension sheet for the precise po‐
sition of the threaded holes
page
13.
The machine manufacturer has to consider the special characters
of his construction and must work out special mounting instruc‐
tions for the rotor and stator motor components. The machine
manufacturer's mounting instructions are the only binding guide‐
lines.
WARNING
When assembling the rotor to the motor spindle, heat up
the rotor to a temperature between +180 °C and +200 °C.
Assemble the rotor with utmost caution. Wear heat-resist‐
ant working clothes and safety shoes.
Assemble the rotor with the machine manufacturer's installation instructions.
The machine manufacturer must consider the special character of his con‐
struction and must work out special mounting instructions.
The project planning manual
tions for general guidance. It describes a schematic structure without consid‐
ering constructive specials of the machine. The procect planning manual also
show parts that are required but are maybe not included in the Bosch
Rexroth delivery and must be appropriately dimensioned and provided by the
user.
DOK-MOTOR*-1MB********-IT01-EN-P
Rexroth 1MB Kit Spindle Motor
Ground connection
Number
Dimensions
(per front face)
8
M8 / 22 mm
deep
(one side only)
8
M8 / 22 mm
deep
(one side only)
fig. 1-1 "Additional documentation" on
Burns due to hot surfaces with temperatures
over +100°C when shrinking the rotor onto
the motor spindle!
Rexroth 1MB includes installation instruc‐
Number
(per front face)
1
(one side only)
1
(one side only)