Table of Contents
Advertisement
16/61
Bosch Rexroth AG
Safety Instructions
2.3
Non-Intended Use
Property right of third party
2.4
Personnel Qualification
2.5
General Safety Instructions
2.6
Product and Technology-Dependent Safety Instructions
2.6.1
Protection against Electrical Voltage
Any use of the motors outside of the specified fields of application or under
operating conditions and technical data other than those specified in this doc‐
umentation is considered to be "non-intended use".
Direct operation on the three-phase network and use in hazardous areas
(ATEX) are forbidden.
The property rights of third parties have to be observed by the customer
when assembling and using individual components of Bosch Rexroth. In the
case of infringement, the customer itself is held liable for the resulting dam‐
age.
For the purpose of this manual, means persons who are familiar with trans‐
porting, installing, mounting, commissioning and operating the components of
the electrical drive and control system and the associated hazards and have
an appropriate qualification for their job.
All persons working on, with or in the vicinity of an electrical system must be
informed of the relevant safety requirements, safety guidelines and internal
instructions (DIN EN 50110-1).
Do not install or operate motors or components of the electric drive and con‐
trol system before you have not carefully read and understand all delivered
documents.
Please observe the particular applicable national, local and system-specific
regulations, the in the documentation and the warning and informative labels
on the motors.
Improper use of the motors and failure to follow the safety instructions in this
document may result in material damage, personal injury, electric shock or, in
extreme cases, to death!
For damage due to non-compliance with the safety instructions, Bosch
Rexroth does not assume any liability.
Work required on the electric system may only be carried out by skilled elec‐
tricians. Tools for electricians (VDE tools) are absolutely necessary.
Prior to commencing the work:
1. Isolate.
2. Protect the system or plant against restart.
3. Ensure de-energization.
4. Ground and short-circuit.
5. Cover or shield any adjacent live parts.
After completion of the work, unmake the measures in reverse order.
During operation, dangerous voltages occur! Danger! Risk of injury due to
electric shock!
DOK-MOTOR*-1MB********-IT01-EN-P
Rexroth 1MB Kit Spindle Motor
Advertisement
Table of Contents
