Table of Contents
Advertisement
DOK-MOTOR*-1MB********-IT01-EN-P
Rexroth 1MB Kit Spindle Motor
7
Commissioning and Operation
7.1
Safety
7.2
Commissioning
WARNING
Live parts are dangerous.
Do not open any covers or flange sockets during operation.
Never connect or disconnect plug connectors and connec‐
tion terminals under load!
WARNING
Do not remove any covers, machine parts or protection de‐
vices during operation.
Do not enter the range of movement of the machine. Pre‐
vent persons from entering this area, e.g., by means of
●
safety fence, safety guards, protective covers
●
Optical sensors
CAUTION
Do not touch hot motor surfaces.
Install protection against contact, if necessary.
Make sure that no temperature-sensitive components (ca‐
bles, electronic components, ...) touch hot surfaces.
The motor can be operated only after installation into a machine.
For start up, please observe the documentation of all system
components. For detailed start up procedure of the motors refer
to the project planning manual
tive documentation about the drive controller or firmware descrip‐
tion.
Prior to commissioning, ensure that the following requirements are met.
●
Make sure that the motor cooling and also the motor are mechanically
and electrically connected correctly.
●
Ensure that the motor and all participating components of the drive (e.g.
encoder, cooling system, brake ...) are undamaged and operating cor‐
rectly.
●
Make sure that the axis can freely rotate over the whole rotational area.
●
Please observe the general safety instructions on the protection against
hazardous movements
Hazards" on page
17.
Bosch Rexroth AG
Commissioning and Operation
High electrical voltage! Danger to life, risk of
injury due to electric shock.
Risk of injury due to rotating motor shaft!
Thermal danger due to hot surfaces with tem‐
peratures over 70 °C during operation
Rexroth 1MB and the respec‐
chapter 2.6.2 "Protection against Mechanical
41/61
Advertisement
Table of Contents
