Table of Contents
Advertisement
Appendix C. Programming the XGS868i Using PanaView™
C.6.2b Setting Up Option Cards
The Model XGS868i has two built-in analog outputs, which are assigned to
cards may be installed in
available option cards.
To access this submenu, double-click on the Options entry in the Input/Output submenu. This menu option is used to
set up and/or scale the inputs and outputs. To accomplish this, complete the following steps:
•
Double-click on the desired I/O Slot to program the I/O functions in that slot.
Note: If an option card is not installed in Slot 1, the
Proceed to the appropriate section for programming instructions specific to the type of input or output selected above.
Analog Outputs
Complete the following steps to set up the analog outputs for any slot (refer to Figure 55 on page 142):
1. Double-click on the desired Output (A or B).
Note: The set up of output A is used here as an example. Identical procedures would be used to set up output B.
2. Double-click on Off to disable Output A and return to step 1, or on 0-20 mA or 4-20 mA to specify the desired range
for output A.
Note: For a 1-Channel meter, proceed to step 4.
3. Double-click on the desired Channel option. See Table 26 for a description of the channel options available.
4. Double-click on the desired Measurement Name. (Table 27 on page 117 provides a description of the available
parameters.)
116
Slot 1
. See Chapter 1, Installation, of the Startup Guide for a complete description of the
Table 26: Channel Options
Option
Channel 1
Channel 2
Add Channels
Subtract Channels
Average Channels
Slot 0
Slot1
option does not appear at the above prompt.
Description
Channel 1
Channel 2
CH1+CH2
CH1-CH2
(CH1+CH2)/2
. Also, a variety of input/output option
DigitalFlow™ XGS868i Programming Manual
Advertisement
Table of Contents
