GE DigitalFlow XGS868i Programming Manual page 128

Appendix C. Programming the XGS868i Using PanaView™
Option Bar
Displays Skan Delta T.
2
DeltaT S
Displays Measure transit time upstream.
2
UP Transit M
Displays Measure transit time downstream.
2
DN Transit M
Displays Measure Delta T.
2
DeltaT M
Vinst Displays the instantaneous velocity.
T Saturat Displays saturation temperature for steam at current pressure.
Displays actual temperature minus the saturation temperature
T Superht
(Tactual – Tsat).
Fluid Dens Displays fluid density.
T Kelvin Displays the current process temperature in °K.
kiloPascals Displays the current process pressure in kPa
Displays the steam quality from a live input or a static
Steam Quality
programmed value.
1
available only if Multi K-factors = ON
2
available only if Burst Mode = S/M
Note: The measurement units that appear in these prompts are those selected in the
this section.
Analog Outputs (cont.)
5. Enter a flow rate value for the Zero (low) end of the analog output range and click [Next Item].
6. Enter a flow rate value for the Full (high) end of the analog output range and click [Next Item].
After responding to the above prompt, the meter returns to step 1. Click [Exit Page] to proceed to another menu or
option.
118
Table 27: Available Measurement Parameters (cont.)
Description Good
N.A.
N.A.
N.A.
N.A.
N.A.
N.A.
0
N.A.
N.A.
N.A.
0.0 – 1.0
Global-System
menu earlier in
DigitalFlow™ XGS868i Programming Manual
Bad
N.A.
N.A.
N.A.
N.A.
N.A.
N.A.
<0
N.A.
N.A.
N.A.
<0.0 or >1.0