Table of Contents
Advertisement
2.2.2 Programming the LCD (cont.)
8. Scroll to the desired Channel option, as listed in Table 13.
9. For each channel, select the desired Measurement Parameter, as shown in Table 9 on page 26.
Note: The measurement units that appear in these prompts are those selected in the
manual. Also, when differences in one channel's programming invalidate an output previously chosen for the
other, the measurement defaults to the nearest selectable item in the parameter list.
The previous two prompts repeat until all of the specified # of LCD Parameters have been set up. When all of the
display parameters have been set up, the meter returns to the
[Escape]
the
key three times.
After leaving the Keypad Program, the XGS868i will reset itself and will begin to display the parameters specified in
this section. If more than one parameter was set up, each of the parameters will be displayed in sequence, with a pause
of several seconds between display changes.
DigitalFlow™ XGS868i Programming Manual
Table 13: Channel Options
Option
Description
CH1
Channel 1
CH2
Channel 2
SUM
CH1+CH2
DIF
CH1-CH2
AVE
(CH1+CH2)/2
Global I/O
GLOBL-SYSTM
window. To leave the Keypad Program, press
Chapter 2. Displaying Data
menu earlier in this
45
Advertisement
Table of Contents
