10/100/1000 Ethernet Management Ports - Hitachi NAS Platform 4000 Series Hardware Reference Manual

Terminal
Connection
Emulation
Baud rate
Data bits
Stop bits
Parity
Flow control
Note: Once the initial setup has been completed, disconnect the serial cable.
If you need to manage the server through a serial connection, connect to the
serial port on the external SMU and use SSH to access the server's CLI. If your
system does not include an external SMU, connect to the server's embedded
SMU and use SSH to access the server's CLI.

10/100/1000 Ethernet management ports

The 10/100/1000 Ethernet management ports are used to connect the server or node to
the customer facing management network and the private management network, or to
connect directly to another device for management purposes.
The 10/100/1000 Ethernet ports operate at speeds of up to one (1) gigabit per second,
and require the use of a standard RJ45 cable connector. Once connected, each GE port
has two indicator LEDs; one on the top left and the second on the top right of the port.
These LEDs provide link status and network activity status information as described in
the next table:
Left LED - Speed
Off
Green
(not flashing)
Orange
(not flashing)
Off
Hitachi NAS Platform and Hitachi Unified Storage Series 4000 Hardware Reference
Table 20 Host setting values
Crossover (null modem) cable
VT100
115,200 Bps
8
1
None
None
Right LED - Link/
Activity
Yellow
(flashing)
Yellow
(flashing)
Yellow
(flashing)
Off
Chapter 4: Hitachi NAS Platform server components
10/100/1000 Ethernet management ports
Requirement
Meaning
10 Mbps link present
100 Mbps link present
1 Gbps link present
No link
61