Optional) Installing A Wall-Mounted Ai/Di Module - Huawei ECC500 User Manual

ECC500
User Manual
Figure 4-5 Installing floating nuts
Step 2 Install long mounting ears on the AI/DI module.
Step 3 Secure the AI/DI module in the cabinet by tightening the M6 screws clockwise on the right
and left mounting ears, as shown in
Figure 4-6 Installing a rack-mounted AI/DI module
----End

4.2.4 (Optional) Installing a Wall-mounted AI/DI Module

Prerequisites


Procedure
Step 1 Install mounting ears on the AI/DI module in the position and direction shown in
Step 2 Place the AI/DI module at the installation position on the wall and mark the mounting ear
hole positions using a marker.
Step 3 Drill holes at the marked installation position (hole spacing: 52 mm x 205 mm) on the wall
using a hammer drill, and install four M8 expansion bolts into the holes.
Step 4 Install the AI/DI module at the expansion bolts on the wall and ensure that the rear panel of
the module is flush with the wall.
Issue 03 (2020-01-06)
Ensure that the floating nuts on both sides are on the same horizontal line.
The installation position on the wall has been determined.
The following tools are available: Phillips screwdriver, flat-head screwdriver, hammer
drill (Φ10 bit), socket wrench, marker, and rubber mallet.
Copyright © Huawei Technologies Co., Ltd.
Figure 4-6.
4 Installation and Commissioning
Figure 4-7.
33