The exact failure cause can be read from FBP (see also next paragraph).
is
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.9.2
Troubleshooting
Depending on the status and behaviour of the LEDs it's possible to get locally some informa-
tion:
#
Symptom
1.
Some or all LEDs still ON after start-up sequence
2.
- TX LED flashes (very fast) and
- FAULT LED flashes at 2 Hz and
- FBP LED flashes at 2 Hz
3.
FAULT LED flashes at 2 Hz
NOTE: the PWD LED is always ON if the EP010 is powered.
ABB SACE
Please note that NO communication between FBP and EP010 is active if there
a failure on the relevant serial channel (UART).
Table 8. Troubleshooting
EP010
Diagnosis
SW/HW bug
No response from the device
- Previously detected fault and
- no communication with the FBP
1SDH000510R0001
Page N.
L2388
13/28