Installation; Electrical Connection - Siemens SINAMICS S120 System Manual
High frequency drive
Hide thumbs
Also See for SINAMICS S120:
- Function manual (1094 pages) ,
- Diagnostic manual (947 pages) ,
- Manual (848 pages)
Table of Contents
Advertisement
6.6
Installation
The Voltage Protection Module is installed in the control cabinet close to the HF Choke Module.
Figure 6-6
6.7
Electrical connection
Note
Only the enclosure cover may be opened when electrically connecting the Voltage Protection
Module.
Introduction
Various types of cabling work must be carried out in order to integrate a Voltage Protection
Module into a motor feeder circuit. All connections must be set up inside the VPM enclosure.
Cable cross-sections are determined by the rated motor power and can be up to 2 x 50 mm
each conductor.
High Frequency Drive
System Manual, 10/2020, 6SL3097-5AH10-0BP0
Mounting dimensions for a Voltage Protection Module VPM 200 Dynamik
Voltage Protection Module (VPM)
6.7 Electrical connection
2
for
89
Advertisement
Table of Contents
