Routing Parameters; Configuring The Network Monitor - ABB ARR600 User Manual

1MRS758458 F
5.3
5.4
ARR600
User Manual

Routing parameters

The device has multiple configuration options that define routing.
Table 10: Routing parameters
Screen Parameter
Ethernet WAN Gateway (IP address)
WAN Failover WAN Default Route
On Demand
Primary WAN Interface
Backup WAN Interface
Secondary Backup
WAN Interface
OpenVPN Client Interface
Settings
Routing mode

Configuring the network monitor

The network monitor detects Internet connectivity drops by sending ping packets to
designated targets. Its use is recommended.
Network configuration
Value Description
(IP address) IP address of router
used to reach the
internet. If not used,
the field should be
empty.
Yes Usually "Yes" if the
No default route is defined
by "static routes". "No"
is required if the
selection logic is done
on VPN level.
Yes "Yes" activates the
No backup interfaces only
when required. "No"
makes all the WAN
interfaces available
simultaneously, for
example, for VPNs.
None These three settings
Mobile WAN configure the high-
Ethernet WAN level default gateways.
Ethernet WAN They must be
Secondary configured to enable
default route.
None
Mobile WAN
Ethernet WAN
None
Mobile WAN
Ethernet WAN
Ethernet WAN
Secondary
Any WAN This setting defines
Ethernet WAN which interface to use
Wireless WAN for connection.
Ethernet LAN
None This setting defines
Host how the routing is
Net configured with
Default route OpenVPN. See
OpenVPN application
note.
Section 5
27