Coating Materials List - Komatsu PC88MR-10 Shop Manual

50 Disassembly and assembly
Related information on disassembly and assembly

Coating materials list

a The coating materials such as adhesives, liquid gasket, and grease used for disassembly and assembly
are listed below.
a For coating materials not listed below, use the equivalent of products shown in this manual.
Adhesive
Komatsu code
LT-1A 790-129-9030
LT-1B 790-129-9050
LT-2 790-129 9180
790-129-9060
LT-3
Set of adhesive
and hardener
LT-4 790-129-9040
Holts MH705 790-129-9120
ThreeBond 1735 790-129-9140
Aron Alpha 201
790-129-9130
Loctite 499 428-99-80070
Loctite 648-50 79A-129-9110
50-6
(ALL-3540-071-A-00-A)
Capacity
Part No.
150 g
20 g
(contained 2
pieces)
50 g
Adhesive:
1 kg
Hardener:
500 g
250 g
75 g
50 g
2 g
(contained 5
pieces)
20 cc
50 cc
Main features and applications
Container
Use to prevent rubber gaskets, rubber
Tube cushions, and cork plugs from coming
out.
Use for plastic (except polyethylene,
polypropylene, tetrafluoroethylene and
Polyethy-
vinyl chloride), rubber, metal, and non-
lene
metal parts which require immediate
container
and strong adhesion.
Features: Resistance to heat and
Polyethy-
chemicals
lene
Use to prevent bolts and plugs from
container
coming loose and as sealant.
Use to bond and seal metal, glass and
Can
plastics.
Polyethy-
Use to seal plugs for blank holes.
lene
container
Heat-resistant seal used to repair
Tube
engines
Instantaneous adhesive
Polyethy-
Curing time: From 5 sec. to 3 min.
lene
Use mainly to bond metals, rubbers,
container
plastics, and woods.
Instantaneous adhesive
Polyethy- Quick-curing type (max. strength is
lene obtained after 30 minutes)
container Use mainly to bond rubbers, plastics,
and metals.
General-purpose instantaneous
adhesive with excellent resistance to
heat and impact
Tube
Use on the bushing mounting faces of
axle supports.
Features: Resistance to heat and
Polyethy-
chemicals
lene
Use to bond high-temperature fit parts.
container
(Rev.2012.11)
PC88MR-10