Removing the fuse board
To replace the channel fuses, the board on which the fuse to be replaced is located must be
removed from the POM.
NOTICE
ESD-sensitive components
Before you remove the board, please note the ESD information in Section ESD Guidelines
(Page 145).
Tool
You will need a Torx T8 screwdriver.
Proceed as follows to remove it:
Image 12-1
Removing the fuse board
Steps
1
Loosen the two screws on the top and bottom of the fuse module
②
2
Unlatch retainer
③
3
Remove board
4
Place board on an ESD-compatible surface
SIPLUS HCS4300
Operating Instructions, 11/2015, A5E35452705A/002
Service and maintenance
12.3 Fuse replacement
①
109