Table of Contents
Advertisement
Chapter 2 Preparations
8.
Insert the riser card into the slot on
motherboard.
When connecting the card, position the
terminal part of the card to the slot on the
motherboard and insert it.
9.
Secure the card with two screws you
removed in Step 2.
10. Continue to install or remove internal optional devices, mount and connect the server, and turn it on.
11. Make sure that no error messages are displayed on POST screen.
For details on POST error messages, refer to Chapter 3 (1. POST Error Message) in "Maintenance
Guide".
12. Start the BIOS Configuration utility on the mounted board to set up the board.
Availability or startup and operation procedure of the utility depends on board. For details, refer to the
manual that comes with the board. If a PCI card including RAID Controller and LAN card which connects
to any bootable device is added, the boot priority might be changed to the default setting. In that case,
configure the boot priority in the Boot menu of the BIOS Setup utility. For details about the Boot menu,
refer to Chapter 2 (1.2.5 Boot) in "Maintenance Guide".
(1)
When using the optional controller (N8103-172/173/174/168)
For details, refer to the manual that comes with optional RAID Controller (N8103-172/173/174/168).
• You must avoid static electricity to work with the procedure below. For
Important
details, refer to Chapter 2 (1.2 Anti-static Measures).
• Do not change the mode to hibernate when building a RAID System.
• When installing an optional RAID Controller, start the BIOS Setup utility, select
Note
PCI Configuration from the Advanced menu, and then make sure that the
parameter of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.
• When connecting a RAID Controller, set the boot priority to 8th or higher in the
Boot menu of the BIOS Setup utility. If the setting is 9th or lower, the configuration
menu for RAID Controllers cannot be launched.
Express5800/R120e-2E User's Guide
1. Installing Internal Optional Devices
89
Advertisement
Table of Contents
