Installing Fbu - NEC Express5800/R120e-2E User Manual

Chapter 2 Preparations

1.11.4 Installing FBU

Take the steps below to install FBU.
See steps 1 to 6 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
1. Put the FBU, provided as the standard
accessory of RAID Controller, on the
support bar. Then, mount the FBU bracket,
provided as the standard accessory of
RAID Controller, and secure it with a
screw.
2. Connect the FBU control cable (600 mm),
provided as the standard accessory of
RAID Controller, to FBU.
3. Remove the screw securing the riser card.
Hold the both ends of the riser card and lift
it off.
Note
Be careful not to contact with other parts.
Express5800/R120e-2E User's Guide
1. Installing Internal Optional Devices
Screws
77