No
Item
8
9
10
11
12
13
4‐10
Function
Single/Bundle cutting
mode
Coolant ON/OFF
Slow material feeding
mode
Trim cut ON/OFF
System parameter
setting
Cutting parameter
setting
Description
has been turned on.
This button is used to switch between single or bundle
cutting mode.
Switch to single cutting model (
work piece.
Switch to bundle cutting mode (
work pieces.
When under bundle cutting mode, the feeding vise
must be touching the front limit switch for the blade to be
able to start.
Press this button to turn on the coolant pump.
A solid yellow faucet icon indicates the coolant pump has
been turned on.
Press again to turn off the coolant pump.
Used only when under Manual mode.
When the slow material feeding mode is turned on, the
material feeding speed will dramatically reduce to help you
position the work piece precisely.
This selection button works with the AUTO mode.
When under AUTO mode and before proceeding with your
automatic cutting jobs, select +0 if you wish the first cut to
be "trim cut" i.e. trimming the edge of your material without
the cut being counted into the "finished cuts."
In the other hand, select +1 if you do not need to trim cut
the material. The first cut will then be counted as the first cut
of your programmed jobs.
After the first cut begins, you may still change your
selection before the saw bow has descended to its lowest
point.
Press this button to set up system parameters. Password is
required.
All parameters have been set up by the manufacturer.
In order to prevent random change from being made to
these parameters and affect cutting precision and machine
life, this function is protected with a set of password.
Press this button to display cutting‐related information e.g.
total number of cuts completed and feeding length OR to set
parameters e.g. cutting lengths and quantity. (A total of 100
) to cut a single
) to cut a stack of