MAINTENANCE SCHEDULE
We suggest you do the maintenance on schedule.
Before beginning a day's work
1. Please check the hydraulic oil level. If oil level volume is below 1/2, please add oil as necessary.
(Filling up to 2/3 level is better for system operation.)
2. Please check the cutting fluid level, adding fluid as necessary. If the fluid appears contaminated
or deteriorated, drain and replace it.
Do not discharge cutting fluid while the saw blade is operating because it will cause severe
injury on operator's hand.
3. Please check the saw blade to ensure that it is properly positioned on both the drive and idle
wheels.
4. Please make sure that the saw blade is properly clamped by the left and right inserts.
5. Please check the wire brush for proper contact with the saw blade. Replace the wire brush if it is
worn out.
After ending a day's work
Please remove saw chips and clean the machine when work has been completed.
Be sure the saw blade is fully stop.
Every week
Clean and lubricate the following:
1. feed cylinder surfaces
2. vise slideway.
Recommended lubricant:
Ordinary lubricant
Every 2 weeks
Please apply grease to the following:
1. Idle wheel
2. Drive wheel
Recommended Grease:
Shell Alvania EP Grease 2
Mobil Mobilplex 48
8‐2