NEC Express5800 Series Maintenance Manual page 186

Chapter 3 Appendix
Error
Class
code
UEFI 261
UEFI 266
UEFI 267
UEFI 268
UEFI 269
UEFI 270
UEFI 271
UEFI 272
UEFI 276
UEFI 277
UEFI 278
UEFI 281
186
Error message
Server Platform Services Firmware
requires update.
Non-Volatile Memory Corruption Detected.
Configuration settings restored to defaults.
If enabled, Secure Boot security settings
may be lost.
IMPORTANT: Default configuration settings
have been restored at the request of the
user.
UEFI Non-Volatile Variable Store
Corruption Detected. If enabled, Secure
Boot security settings may be lost.
IMPORTANT: Default configuration settings
have been restored per user request. If
Secure Boot was enabled, related security
settings may have been lost.
%1 FW Communication Issue - Unable to
communicate with %2 FW. Certain
management functionality is not available.
Processor %1, DIMM %2 could not be
authenticated as genuine %3. Enhanced
and extended %4 features will not be
active.
IMPORTANT: Processor %1, DIMM %2
may not be a Genuine %3 DIMM.
Option Card Configuration Error. An option
card is requesting more memory mapped
I/O than is available.
Secure Boot Authentication Failure - The
image on %1 failed authentication and was
not executed.
Secure Boot Authentication Failure - The
image on %1 was not authorized due to
revoked certificate(s) and was not
executed.
IMPORTANT: SW12 is ON indicating
physical presence. This switch should only
be ON to override certain security
protections.
Express5800/R120h-1E, R120h-2E Maintenance Guide
Action
Update the server platform service firmware. If the
problem persists, contact your sales representative.
The system configuration has been initialized to default.
Make the necessary settings in the system utility. If the
problem persists, contact your sales representative.
The system configuration has been initialized to default.
Make the necessary settings in the system utility. If the
problem persists, contact your sales representative.
The system configuration has been initialized to default.
Make the necessary settings in the system utility. If the
problem persists, contact your sales representative.
The system configuration has been initialized to default.
Make the necessary settings in the system utility. If the
problem persists, contact your sales representative.
Turn off the unit, disconnect the power cord, wait 30
seconds, and then restart it.
If the problem persists, contact your sales
representative.
The DIMM failed to be authenticated as an authorized
part. Check the DIMM connected to the unit. If the
problem persists, contact your sales representative.
The DIMM failed to be authenticated as an authorized
part. Check the DIMM connected to the unit. If the
problem persists, contact your sales representative.
The memory space for the optional card failed to be
allocated. Remove the added optional card so that the
system can be booted. If the problem persists, contact
your sales representative.
If the error occurs due to adding of the optional card,
check whether the added card supports the secure
boot. If the problem persists, contact your sales
representative.
If the error occurs due to adding an optional card, make
sure whether the added card meets the conditions
required for secure boot. If the problem persists, contact
your sales representative.
Set the maintenance switch SW12 to OFF unless the
setting is specified in the operating procedure etc.
When operating the maintenance switch, follow the
procedure in Chapter 1 (7. Resetting and Clearing the
Server) in this manual.
If the problem persists, contact your sales
representative.
1. IML Error Message