NEC Express5800 Series Maintenance Manual page 210

Chapter 3 Appendix
Error
Class
code
UEFI 412
UEFI 413
UEFI 436
UEFI 450
UEFI 452
UEFI 453
UEFI 457
UEFI 462
UEFI 471
UEFI 3010
210
Error message
Server Platform Services Firmware Error -
The Server Platform Services firmware is
operating in factory mode.
Innovation Engine Image Authentication
Error. The Innovation Engine image could
not be authenticated.
Scalable Persistent Memory on %1 Logical
NVDIMM %2 does not have enough
memory to initialize.
%1 is in High Security Mode and there is
no System ROM Admin Password set.
%1 FW Communication Issue - Unable to
communicate with %2 FW. One or more
configuration settings may be used from
the last system boot. One or more
configuration changes since the last boot
may not have taken affect.
Unsupported DIMM Configuration
Detected - Processor %1 DIMM %2.
Unsupported persistent memory module is
present in the system. This module is not
supported by the installed processor(s).
-System Halted!
%1 FW Communication Issue - Unable to
communicate with %2 FW (Error Code
0x%3). Unexpected %4 behavior may
occur.
Uncorrectable Memory Error Threshold
Exceeded (%1 %2, DIMM %3). The
DIMM is mapped out and is currently not
available.
IMPORTANT: The UEFI Variable space is
close to exceeding the non-volatile storage
capacity. This may impact OS
installations and may limit the ability to
configure certain options.
MemBIST RMT: %1 margin out of range at
CPU %2 DIMM %3 - Count %4
Express5800/R120h-1E, R120h-2E Maintenance Guide
Action
Update the system ROM and Server Platform Services
Firmware.
If the problem persists, contact your sales
representative.
Update Innovation Engine Firmware.
If the problem persists, contact your sales
representative.
Confirm an additional DIMM is unnecessary. Instead,
confirm an additional record about a memory error in
Integrated Management Log (IML). If there is an
additional record, follow on how to deal with the
additional record. If the problem persists, contact your
sales representative.
Restart the unit after setting the Admin password for the
system ROM.
Please take actions in following order.
1. Turn off the unit, disconnect the power cord, wait 30
seconds, and then restart it.
2. If the problem persists, updating the corresponding
firmware may solve the error. Please update the
corresponding firmware.
3. If the problem persists, contact your sales
representative.
Remove the persistent memory which was pointed out.
For the details of the DIMM configuration, refer to the
User's Guide. If the problem persists, contact your sales
representative.
Please take actions in following order.
1. Turn off the unit, disconnect the power cord, wait 30
seconds, and then restart it.
2. If the problem persists, updating the corresponding
firmware may solve the error. Please update the
corresponding firmware.
3. If the problem persists, contact your sales
representative.
Contact your sales representative.
Restore the factory default settings using the "Restore
Default Manufacturing Settings" option via System
Configuration > BIOS/Platform Configuration
(RBSU) > System Defult Options in the system utility.
If the problem persists, contact your sales
representative.
Contact your sales representative.
1. IML Error Message