NEC Express5800 Series Maintenance Manual page 188

Chapter 3 Appendix
Error
Class
code
UEFI 320
UEFI 321
UEFI 322
UEFI 323
UEFI 324
UEFI 325
UEFI 326
UEFI 327
UEFI 328
UEFI 329
UEFI 333
188
Error message
Enclosure Power Event detected. Boot
delayed until condition is resolved.
%1 Dual microSD Device Unsupported
Configuration - A microSD card is not
installed in Slot %2
%1 Dual microSD Device Unsupported
Configuration - No microSD cards are
installed.
%1 Dual microSD Device Error - The
microSD card in Slot %2 has failed.
%1 Dual microSD Device Error - Both
microSD cards have failed.
%1 Dual microSD Device Error - microSD
cards have conflicting metadata.
Configuration required.
%1 Dual microSD Device Error - The
microSD card in Slot %2 has failed. A
microSD card is not installed in Slot %3.
AMP Configuration Error - An installed
processor does NOT support the
configured AMP Mode. System will
operate in Advanced ECC Mode.
Power Management Controller Firmware
Error - The firmware is in Recovery Mode.
Power Management Controller FW Error -
Unable to communicate with the FW.
%1 RESTful API Error - Unable to
communicate with iLO FW. BIOS
configuration resources may not be
up-to-date.
Express5800/R120h-1E, R120h-2E Maintenance Guide
Action
Action is not necessary.
Make sure whether the corresponding microSD card is
correctly mounted. If the problem persists, contact your
sales representative.
Make sure whether the corresponding microSD card is
correctly mounted. If the problem persists, contact your
sales representative.
Contact your sales representative.
Contact your sales representative.
Use the system utility to set up the primary microSD
card. If the problem persists, contact your sales
representative.
Contact your sales representative.
Contact your sales representative.
Update the firmware of the power management
controller. If the problem persists, contact your sales
representative.
Please take actions in the following order.
1. Turn off the unit, disconnect the power cord, wait 30
seconds, and then restart it.
2. If the problem persists, contact your sales
representative.
Please take actions in the following order.
1. Reset the iLO following the procedure of Chapter 1
(7. Resetting and Clearing the Server) in this manual.
Also, restart the unit.
2. If the problem persists, turn off the power of the unit,
disconnect the power cord, wait 30 seconds, and then
restart it.
3. If the problem persists, contact your sales
representative.
1. IML Error Message