Table of Contents
Advertisement
Test Development Overview
The development of a device test is an iterative process:
1 Set up the test.
2 Run the test.
3 Check the test results.
4 Modify test parameters.
5 Repeat steps 2 to 4 until the results are adequate.
6 Save the final setting for reuse.
All these steps are supported and simplified by the graphical user interface
of the HP 81200 Data Generator/Analyzer Platform.
This chapter provides an overview:
"Procedure for Setting Up the Test" on page 51
"Procedure for Running the Test" on page 53
"Procedure for Viewing Test Results" on page 54
"Procedure for Saving the Test Setting" on page 55
50
HP 81200 Data Generator/Analyzer Platform User Guide, Revision 2.1
Advertisement
Table of Contents
