Table of Contents
Advertisement
94
Connecting the DUT
To connect the device under test (DUT) with the HP 81200 system, you
will:
• Create ports.
There are data input ports, data output ports, and pulse ports.
• Change port characteristics.
You can add terminals to ports. You can also remove terminals from a
port, rename the port or delete it.
N O T E
Terminals (individual pins) can only be defined within a port.
• Change terminal characteristics.
You will connect the terminals with suitable module connectors. You
can also move a terminal, rename it, or disconnect it.
All this can be done from the Connection Editor.
After at least one terminal has been connected, the Connection Editor is
also used to access the Parameter Editor for setting port and terminal
specific properties.
N O T E
Of course, physical connections are required as well. But you need only
take care that the physical connections are in agreement with the setting
shown by the Connection Editor.
This chapter explains how to use the Connection Editor:
"How to Start the Connection Editor" on page 95
"How to Create a Port" on page 97
"How to Change the Characteristics of a Port" on page 99
"How to Change the Characteristics of a Terminal" on page 101
HP 81200 Data Generator/Analyzer Platform User Guide, Revision 2.1
Advertisement
Table of Contents
