Delayed Start; Load Program - Electrolux SMART Operating Instructions Manual

OPERATING INSTRUCTIONS | SMART LINE | BOILING PAN
If the display shows - h -- min, this means that there
is unrestricted time and the pan must be switched
off using STOP .
• Confirm by pressing Menu forwards
The following settings appear in the display (if
the flow sensor option has been selected):
BOILING
SET WATER
NOTE: The settings do not work while manual wa-
ter filling is in progress.
4.
Press Increase value
number of litres of water to be filled.
If there is a value in brackets ( ) in the display, this
specifies how many litres of water have already
been filled into the pan.
• Confirm by pressing Menu forwards
The following settings appear in the display (if
the flow sensor and mat temp sensor options
have been selected):
BOILING
Xh XXmin XXX°C
WATER XL
-- --
To select the settings made without saving:
5.
Press Menu forwards
Continued from step 7.
To save the settings that have just been made:
•
Press Increase value
The following text appears in the display:
BOILING
Xh XXmin XXX°C
WATER XL
6.
The number of a free program flashes in the
display.
Other numbers, that are not flashing, are not se-
lected here. (See Changes in existing programs).
• Select this free program number by pressing
Menu forwards .
Tip! Write down the program number.
rpm = revolutions per minute
20
once.
(XXX+) XXXL
for setting the
once.
twice.
01
DOC.N
O

13.4 Delayed start

(if the flow sensor and/or mat temp. sensor op-
tions have been selected). If Delayed start has been
deselected, this menu is not shown (see Page 18).
Press Menu forwards
The following text appears in the display:
DELAYED START
SETTING TIME
7.
Press Increase value
delay to the start (max 99h 59min) or press De-
crease value to shorten the delay.
If no delayed start is required, 00h 00min must ap-
pear in the display.
• Confirm by pressing Menu forwards
The following text appears in the display:
DELAY
Xh XXmin XX°C
WATER XXX+XXX
AGITATOR 000rpm

13.5 Load program

(if the flow sensor and/or mat temp. sensor op-
tions have been selected). If programming has been
deselected, this menu is not shown (see Page 18).
The following text appears in the display:
BOILING
Xh XXmin XXX°C
WATER XL
RETRIEVE PROGRAM
8.
Press Increase value
once.
The following text appears in the display:
BOILING
Xh XXmin XXX°C
WATER XL
RETRIEVE LAST
The last can be the program that was just saved.
The program number does not appear in the display.
• Press Increase value
display all stored programs.
9.
Press Menu forwards
ted program.
• Repeat step 7.
If Programmed start is selected
: ST09184-02
once.
-h --min
to add a longer
once.
XXh XXmin
-- --
or Decrease value
-- --
or Decrease value
to load the selec-
EN | 02-2015
to