Table of Contents
Advertisement
Figure L-17 Fitting the failsafe mechanism
L.5.6
Connect the flexible braided tubing to the inlet and outlet ports of the
product.
▪
Two 1 metre lengths of flexible braided tubing are supplied in each installation kit.
These need to be connected to the inlet and outlet ports of the product to
–
minimise vibration from rigid pipework.
–
allow for position change from the original position (retrofit installations only), so
as not to put stress on the swaged joints and potentially cause leaks.
–
allow for potential movement of the isolator over time. This would cause the
position of the product to change, which may put stress on the swaged joints and
potentially cause leaks.
MA-005 - Minitrans Installation Manual - Rev 4.5
M6 nut, washer and
spring washer
13-Aug-20
Page 63 of 86
Advertisement
Table of Contents
