Table of Contents
Advertisement
▪
Take one of the PGA locks (21-0598) and attach it to the right-hand side of the PGA
between the top and bottom PGA brackets as shown in Figure M-22.
▪
Use two M5 × 30 mm bolts and two rib lock washers to fasten the PGA lock and
tighten with a 4 mm Allen key.
▪
Take the other PGA lock and repeat the previous steps for the left-hand side.
Figure M-22: Fitting PGA lock (clockwise)
▪
Reconnect the fan cable shown in Figure M-23 to the 'Z3 fan' connector on the
marshalling board.
Reconnect the fan cable
at point Z3
Figure M-23: Reconnect the fan cable
MA-005 - Minitrans Installation Manual - Rev 4.5
13-Aug-20
Page 74 of 86
Advertisement
Table of Contents
