Table of Contents
Advertisement
M.3.4.2 Bottom isolators
▪
Partially unscrew the fittings from the front of the bottom two isolators. Pull the large
flat washer forward to allow room to install the locks on the bottom isolators as
shown in Figure M-34.
Figure M-34: Bottom isolators with partially unscrewed fittings
▪
To fasten, add a large flat washer and M6 nut and tighten with a 10 mm spanner as
shown in Figure M-35.
Large flat washer and nut
Figure M-35: Isolator with fittings (left) ¦¦ tightened with spanner (right)
MA-005 - Minitrans Installation Manual - Rev 4.5
[pull forward]
13-Aug-20
Page 81 of 86
Advertisement
Table of Contents
