D-Link DIR-822 User Manual page 30

Ac1200 wi-fi router
Hide thumbs Also See for DIR-822:
Table of Contents

Advertisement

Section 4 - Configuration
Ethernet
The default MAC address is set to the Internet port's physical interface
MAC address:
MAC address on the router. You can edit that address manually here.
Toggle this switch to clone the MAC address of the device you are
Clone MAC
using to access the web UI. Note that no two MAC address within the
address of your
NIC:
same subnet can be the same.
Click here to restore your router's default MAC address.
Restore Default
MAC Address:
Specify the Maximum Transmission Unit of your Internet connection.
MTU:
You may need to change the MTU for optimal performance with your
ISP. The default setting is 1500.
IPv4
Toggle this switch to enable DNS information to be acquired
Obtain DNS
automatically through DHCP. This setting is enabled by default.
server addresses
automatically:
Specify the primary DNS server IP address assigned by your ISP. This
Primary DNS
address is usually obtained automatically from your ISP.
server:
Specify the secondary DNS server IP address assigned by your ISP. This
Secondary DNS
address is usually obtained automatically from your ISP.
server:
Specify a custom vendor ID. (Optional)
Vendor ID:
Specify a hostname here. This will be the name of your router when
Hostname:
viewed from networking tools.
Click Apply when you are done.
D-Link DIR-822 User Manual
Dynamic IPv4 (cont)
26

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents