Section 4 - Configuration
Remote access allows you to access the web GUI from WAN. By default, the access from external networks to the router is
disabled for security reasons. If you need to allow access to the router from external networks, create relevant rules.
Remote Access
Click here to add a new rule, described below.
Add:
Click here to delete a selected rule.
Delete:
Indicates the IP address permitted to access the GUI.
IP address:
Indicates the subnet mask of the IP address permitted to access the
Mask:
GUI.
Indicates the public port over which the IP address is permitted to
Public Port:
access the GUI.
Indicates the protocol used to access the GUI.
Protocol:
Add Rule
Select IPv4 or IPv6.
IP Version:
Toggle this switch to enable any remote host to access the GUI. This
Open access:
is not recommended.
Specify the IP address of the remote host allowed to access the GUI.
IP address:
D-Link DIR-822 User Manual
Remote Access
92