D-Link DIR-822 User Manual page 68

Section 4 - Configuration
Dynamic IP Addresses
Mode of Dynamic Select Disable, Server, or Relay. The default setting is Server
IP address Select Static to assign the IPv4 address, subnet mask, and the gateway
assignment:
IP address manually or Dynamic to automatically obtains these
parameters from the LAN DHCP server or another router.
If DHCP server has been selected, specify the starting IP address in
Start IP:
the DHCP server pool.
If DHCP server has been selected, specify the end IP address in the
End IP:
DHCP server pool.
If DHCP server has been selected, specify the lease time in minutes
Lease Time:
for DHCP-issued IP addresses.
Disable to transfer the DNS server information from your ISP to your
DNS Relay:
computers. If enabled, your computers will use the router for a DNS
server.
Enable for the router to use its MAC address to respond to ARP
ARP Proxy:
requests sent to devices in its LAN.
Disable for the router to use its MAC addresses of devices in its LAN
to respond to ARP requests sent to these devices.
D-Link DIR-822 User Manual
IPv4 (cont)
.
64