D-Link DIR-822 User Manual page 98

Section 4 - Configuration
Virtual Servers allows you to redirect incoming Internet traffic to a specified IP address in
the local area network.
Click on ADD to create a new virtual server and specify the below parameters.
General Settings
Toggle this switch to enable or disable Virtual Servers.
Enable:
Specify a name for the virtual server.
Name:
Choose a template for the virtual server to pre-populate some fields,
Template:
or choose Custom to configure all fields manually.
Select an interface from the drop-down menu, or select <All>.
Interface:
Select a protocol from the drop-down menu to which the rule will
Protocol:
apply.
Toggle this switch to enable NAT loopback.
NAT Loopback:
Public Network Settings Remote IP
Specify the remote IP to which the rule will apply.
Remote IP:
Click this button to add additional remote IP fields.
Add Remote IP:
Specify the remote IP to which the rule will apply.
Public port:
D-Link DIR-822 User Manual
Virtual Servers
94