D-Link DIR-822 User Manual page 75

Section 4 - Configuration
If you have selected Range or single IP address, specify an IP address
Start/End IPv4/
range for the destination filter. To enter a single address, use only the
IPv6 address:
Start IPv4/IPv6 address field and leave the End IPv4/IPv6 address
field blank.
If you have selected Subnet, specify the destination subnet to filter.
Subnet IPv4/IPv6
address:
Source IP Address
Choose Range or single IP address to enter a specific IP address or
Set as:
ranges for the source filter. Choose Subnet to specify a subnet only.
If you have selected Range or single IP address, specify an IP address
Start/End IPv4/
IPv6 address: range for the source filter. To specify a single address, use only the
Start IPv4/IPv6 address field and leave the End IPv4/IPv6 address
field blank.
If you have selected Subnet, enter the source subnet to filter.
Subnet IPv4/IPv6
address:
Ports
Specify the destination port or ports to which the filter will apply.
Destination port:
Specify multiple ports by separating them with commas. Specify port
ranges by separating the beginning and end of the range with a colon.
Toggle this switch to specify source ports to which the filter will apply.
Set source port
manually:
If Set source port manually has been enabled, specify the source
Source port:
port to which the filter will apply. Specify multiple ports by separating
them with commas. Specify port ranges by separating the beginning
and end of the range with a colon.
Click Apply when you are done.
D-Link DIR-822 User Manual 71