Advertisement
3-7. REMOVAL OF CP1 BOARD AND MECHANISM
ASSEMBLY
1 . Remove the three screws CD , and then remove the FPC
(Flexible Printed Circuit)
2. The CP1 board @ is secured to the mechanism assembly
@) by means of positioning bosses (A) and a hook (B).
Therefore, slightly raise the CP1 board ® and slide it to
disengage it from the bosses (A) and the hook (B) . In this
condition, the CP1 board ®can be turned 1 80 °.
@.
3. Disconnect the four FPCs @ , @ , @ and (J) , disconnect
the two ground lead wires ® and ® which are soldered to
the shield case of the CP1 board ® , and then remove
the CP1 board @ from the mechanism assembly @) .
Remove the screw @ , and then remove the AD1 board@
4.
from the terminal bracket @ .
5.
Remove the five screws ® , and then remove the two
b rackets ® and the terminal bracket @ from the mecha
nism assembly @) .
® Screws 1 .4
(#1 1 6)
�
(B) Hook
�
l
@ Bracket
@)Mechanism assembly
- 3-7 -
x 3
® Screws 1 .7
x
4
(# 1 00)
.___
@AD1 board
x 4
(#1 00)
Advertisement
