Installing And Setting Up Diagtools; Net Vectra Pc Users; Vectra Pc & Kayak Pc Workstation Users And Network Administrators - HP Brio 7100 User Manual

NOTE
1 Starting DiagTools

Installing and Setting Up DiagTools

Installing and Setting Up DiagTools

Net Vectra PC Users

If you are a Net Vectra PC user, the Hardware Diagnostics should
already be installed on your PC and be ready to use. To learn how to
run DiagTools on a Net Vectra PC, refer to "Starting DiagTools from the
Hard Disk Drive", on page 9.
Vectra PC & Kayak PC Workstation Users and Network
Administrators
For Vectra PC and Kayak PC Workstation users, as well as network
administrators, you must do the following before you can use
DiagTools:
1 Install the latest version of DiagTools on your PC.
2 Set up DiagTools so that it is ready for use. This means either
creating the diskette(s), or updating the Hardware Diagnostics files
on your Net Vectra PC.
There are two ways to run DiagTools:
From diskettes. The PC boots (or starts) from the first diskette. This
•
is appropriate for all PCs that have a floppy disk drive. This is the
most common way of using DiagTools.
From the hard disk drive. In this case, you select the Hardware
•
Diagnostics option during startup. The Hardware Diagnostics utility
is installed on the hard disk drive. This is only appropriate for Net
Vectra PCs. Net Vectra PCs do not usually have a floppy disk drive.
DiagTools must not be run directly from your operating system.
DiagTools will only function under the DOS operating system and once
the correct drivers have been loaded.
2 English