Sharp SL-5500 Service Manual page 37

2. DISASSEMBLY/ASSEMBLY OF LCD + PWB UNIT
PARTS LIST
No. Part name
1
LCD Unit
2
Main PWB Unit
3
Inverter Holder
4
Inverter Fixing Tape
5
Inverter Unit
6
Sub PWB Unit
7
Screw D
8
Stylus Holder
9
Boss Cap
5
4
3
8
[NOTE FOR DISASSEMBLY/ASSEMBLY OF THE LCD
+ PWB UNIT]
The disassembly procedures of the LCD + PWB Unit are as follows:
The descriptions are made in the following sequence. Check the notes.
7
6
9
1. Sub PWB Unit disassembly
9
2
1
SL-5500 DISASSEMBLY AND ASSEMBLY
– 36 –
1. Sub PWB Unit disassembly
2. Inverter Unit disassembly
3. Inverter Holder disassembly
4. Stylus Holder disassembly
5. LCD Unit disassembly
Remove screws 1 and 2, and remove the Sub PWB Unit.
* Note for assembly
• Before assembling the Sub PWB unit, attach two Boss Caps as
shown in the figure below.
• Insert the B-to-B connector straightly. After insertion, do not twist
it or do not apply a load to it. (It would cause disconnection of the
connector.)
• Tighten the screws in the sequence of 1 to 2.
• When tightening the screws, do not apply an excessive force.
2
When tightening
the screw , hold
2
this section to
prevent the Rib
PWB from rotating.
PC-UM10M
1
When tightening the
screw , hold this
1
section to prevent
the Rib PWB from
rotating.
110
Boss Cap