Motorola MSF 5000 Instruction Manual page 156

Chapter
3
Installation MSF
5000
Instruction Manual
Installation
Overhead Support of
Single
Cabinet
Stacks
1.
Remove and retain
the
four screws from
the top
plastic cap of
the
upper
cabinet. Refer to
Figure
3-7.
Position the two brackets supplied
with
the
stacking
kit
over the top plastic
cap screw holes
of
the
upper
cabinet.
2.
Install and tighten the
four screws (removed in step
1) through
the brackets
into the top plastic cap.
3.
Install and tighten
the
four customer supplied screws through the brackets
into the overhead support.
4.
MSFI026
011494KOM
Figure
3-7
Bracket
Installation for Overhead Support
of Single
Cabinet
Stacks
Overhead Support of Adjacent Cabinet
Stacks
1.
3-14
Remove and retain two screws from
each
of
the adjacent top
plastic caps of
the stacked cabinets. Refer to
Figure
3-8.
Position
the
two brackets supplied with
the
stacking
kit
between the top
plastic cap screw holes of
the adjacent stacked cabinets.
2.
Install and tighten
the
four screws (removed in
step 1) through
the brackets
into the top plastic caps.
3.
Install and tighten
the
four customer supplied screws through
the bracket
into the overhead support.
4.
68P81092E03
3/19/94
Chapter
3 Installation MSF
50
Instruction Manual
Installation
Overhead Support of
Single
Cabinet
Stacks
1.
Remove and retain the four screws from the top plastic cap of the
upper
ca binet. Refer to
Figure
3-7
2.
Position the two brackets supplied with
the
stacking
kit
over the top plastic
cap screw holes of the upper cabinet
3.
Instal
and tighten the four screws (removed in
step 1) through
the brackets
into the top plastic cap
4. Install and tighten the four customer supplied screws through the brackets
into the overhead support
011494KOM
Figure
3-7 Bracket Installation for Overhead Support
of Single
Cabinet
Stacks
Overhead Support of Adjacent Cabinet
Stacks
1.
Remove and retain two screws from
each of the adjacent top
plastic caps of
the stacked cabinets. Refer to
Figure
3-8
2. Position the two brackets supplied with the
stacking
kit
between the top
plastic cap screw holes of the adjacent stacked cabinets
Install and tighten
the
four screws (removed in
step 1) through
the brackets 3.
into the top plastic caps
4.
Install and tighten
the
four customer supplied screws through
the
bracket
into the overhead
support
3-14
68P81092E03 3/19/94