Bottom Anchoring - Motorola MSF 5000 Instruction Manual

MSF
5000
Instruction Manual
Chapter
3
Installation
Bottom
Anchoring
68P81092E03
3/19/94
installation
TIP FOOT
8
4
\
A
SCREWS
MSFI052
021894JNM
Figure
3-11
Tip
Foot Removal
Perform
the
following procedures
to secure
a
nonstacked or stacked cabinet
to the
floor.
Nonstacked Cabinets
On some stations, access
to the
bottom center holes of the plastic cap is blocked.
Slide out
or remove the piece of equipment
blocking access,
if
required. Refer to
Figure
3-12.
O 26" and 37" cabinets
-
Insert the two customer supplied M8 (or
5/16")
shank
diameter screws or
bolts of suitable length through the two bottom center
holes of
the plastic cap into the floor.
OO
46" and 51" cabinets
-
Insert the two customer supplied M8 (or
5/16")
shank
diameter screws or bolts of suitable length through the two holes of the tip
feet
into
the floor.
Slide in
or
install the piece of
equipment blocking access,
if
required.
Stacked Cabinets
Make
sure the
tip
feet are
removed,
if
required.
On some stations, access to the
bottom center holes of the plastic cap is blocked. Slide out or remove the piece of
equipment blocking access,
if
required. Refer to
Figure
3-12.
OO
26",37",
and 51" cabinets
-
Insert the two customer supplied M8
(or
5/16")
shank diameter screws or bolts of suitable length through
the
two
bottom
center holes of the plastic cap into
the floor.
O 46" cabinet
-
O
Using
a
flat blade screwdriver, remove the break-away weld-nut
tab
from
the bottom plastic cap center hole.
O
Insert the
two customer supplied M8 (or 5/16") shank diameter
screws or bolts of suitable length through the two center holes of the
plastic cap into the floor.
Slide in
or
install the piece of equipment
blocking
access,
if
required.
3-17