Rop Setting - Panasonic AK-HRP1010G Operating Instructions Manual

ROP SETTING

Item Setting value
LCD BRIGHT 1 to 20
LED BRIGHT 1 to 5
7SEG-1 BRIGHT 0 to 15
7SEG-2 BRIGHT 0 to 15
BUZZER ON
OFF
CALL PERIOD 0 to 5
CALL CYCLE 0.3 to 1.0
PC_LINK ENABLE
DISABLE
SETTING STORE NO?
SET.1?
SET.2?
SET.3?
SET.4?
SET.5?
SETTING LOAD NO?
SET.1?
SET.2?
SET.3?
SET.4?
SET.5?
C 0 1 : A K - U C 4 0 0 0
R O P S E T T I N G
LCD LED
BRIGHT BRIGHT
10 3
CALL
BUZZER PERIOD
ON 0
PC_LINK
DISABLE
Sets the brightness of the LCD panel.
Set the brightness of the panel buttons.
Sets the brightness of the panel's 7-segment display (group 1). This applies to the ND fil-
ter display, CC filter display, master gain display, and shutter display.
Sets the brightness of the panel's 7-segment display (group 2). This applies to the iris
display and camera selection number / master pedestal display.
Enable or disable the buzzer (beep/call tone).
[CALL PERIOD] and [CALL CYCLE] will be the time from which [CALL] was released for
[CAMERA CCU].
PERIOD: Flashing duration (sec).
CYCLE: Flashing cycle (For 1.0: 500 msec off → 500 msec lit (repeatedly)).
Sets whether to allow communication with ROP Setup Software.
ENABLE: Allows communication. This cannot be selected when an account is not
registered in ROP AUTH SETTING.
DISABLE: Does not allow communication.
NOTE
Set this to "DISABLE" when there will be no communication with ROP
Setup Software.
Stores up to five setting values (SET.1–5) related to the following operations of the unit.
Select the storage destination and then press the dial. If you do not press the dial, the
data will not be stored. You can use this according to purpose of operation.
[MAINTENANCE] > [ROP VOL/BUTTON]
[IRIS LEVER SETTING] > [LEVER MODE]
[IRIS LEVER SETTING] > [PRIORITY]
[IRIS LEVER SETTING] > [RELATIVE MODE]
Select the data stored with U.SETUP STORE in SET.1–5, and reflect the settings in the
following menus by loading the data (pressing the [MENU] dial). You can recall setting
values according to purpose of operation.
[MAINTENANCE] > [ROP VOL/BUTTON]
[IRIS LEVER SETTING] > [LEVER MODE]
[IRIS LEVER SETTING] > [PRIORITY]
[IRIS LEVER SETTING] > [RELATIVE MODE]
- 118 -
1 / 1
7SEG-1 7SEG-2
BRIGHT BRIGHT
7 7
CALL
CYCLE
0.3
SETTING SETTING
STORE LOAD
NO? NO?
Setting details
ROP menu
___ indicates factory default settings.