Hd Dtl - Panasonic AK-HRP1010G Operating Instructions Manual

HD DTL

The control destination differs depending on the unit configuration.
When the camera is an AK-UC4000 or AK-UC3300
The control is performed for the camera.
When the camera is other than the above
When the system format is set to UHD, the control is performed for the CCU. Otherwise, the control is performed for the camera.
The setting values will vary also depending on the connected camera.
Items with the function disabled are indicated by "-".
For details on each setting item, check also the operating instructions of the camera and CCU to be connected.
Item
M.DTL Adjusts the level of master detail.
H DTL LEVEL Adjusts the level of horizontal detail.
V DTL LEVEL Adjusts the level of vertical detail.
PEAK FRQ Sets the peak frequency for the horizontal detail.
V DTL FRQ Set the V DETAIL frequency.
CRISP Set the noise elimination level for the detail signals.
LEVEL DEPEND Set the level of dark detail removal.
DARK DTL Set the level of dark detail enhancement.
DTL SOURCE Selects the source signals for creating the detail components.
GAIN (+) Changes the detail gain level in the + (up) direction.
GAIN (-) Changes the detail gain level in the - (down) direction.
CLIP+ Adjusts detail clipping to minimize scintillation resulting from excessive detail application.
CLIP- This limits the length of the undershoot portion of the detail edge component.
KNEE APERTURE Adjusts the knee aperture level.
DTL KNEE Adjusts the knee detail component.
DTL SW Enables or disables the HD detail effect.
LEVEL DPND SW Removes dark details.
DRK DTL SW Enhances dark details.
C 0 1 : A K - U C 4 0 0 0
H D D T L
H DTL
M.DTL LEVEL
0 15
V DTL
FRQ CRISP
10 10
DTL SOURCE
(G+R)/2
C 0 1 : A K - U C 4 0 0 0
H D D T L
CLIP+ CLIP-
0 0
DTL LEVEL
SW DPND SW
ON OFF
- 87 -
1 / 2
V DTL PEAK
LEVEL FRQ
15 15.0
LEVEL DARK
DEPEND DTL
8 2
GAIN GAIN
(+) (-)
0 0
2 / 2
KNEE DTL
APETURE KNEE
0 0
DRK DTL
SW
OFF
Setting details
ROP menu