Half Speed Command - Toshiba G3 Workbook

Introduction
This application shows a way to make a G3 run at half of its current output frequency (whatever it may be)
upon closure of a contact. This guideline utilizes Override Control to accomplish the desired control.
Connections
ST
SWITCH 1 is located to the right of the phone jack on the control board under the keypad. Make sure it is set to the '10' position. The
'I'/'V' switch does not apply to this guideline.
Programming
Group
UTILITY PARAMETERS
UTILITY PARAMETERS
FEEDBACK PARAMETERS
FEEDBACK PARAMETERS
FEEDBACK PARAMETERS
This works in either panel or remote mode (connect direction reference as usual if in remote mode).
Change Override Change Multiplier to double, quarter, etc. your reference.
For additional assistance, please contact Toshiba Adjustable Speed Drive Marketing Dept. at (800) 872-

Half Speed Command

TERMINAL STRIP
CC
PP RX
Parameter
Blind Function Selection
Feedback Parameters Blind
Override Control Selection
Override Multiplier Input Selection
Override Change Multiplier
2192
19
New Value
1
1
7
3
-50
39